Using Logitech Mice with AUTOCAD
4/15/92

For the Logitech MOUSEMAN SERIAL mouse, all Logitech BUS mice and all Dexxa 
mice, use the following setup:

1] Install ACAD with the Microsoft Bus or Serial Mouse selection.  Be 
   sure to load the DOS mouse driver (MOUSE.COM or MOUSE.SYS) before 
   running ACAD.

The proper scaling factors for bus mice and the MouseMan are as follows:

	Slow Motion Factor:  10
	Fast Motion Factor:  15
	Fast Motion Threshold:  1 or 2

NOTE: Since the Microsoft Bus or Serial Mouse selection causes AutoCad to 
      use the resident mouse driver, this selection will work for ALL 
      Logitech mice (as long as MOUSE.COM or MOUSE.SYS is loaded).

AutoCad (versions 9 and above) can support three buttons with Logitech 
SERIES 9 SERIAL mice and the SERIES 7 SERIAL mice all serial mice except
MouseMan) in one of two ways:

1] Install ACAD with the Logitech Logimouse C7 selection, and DO NOT load 
   the mouse driver.

2] Install ACAD with the Logitech Logimouse R5, R7 selection and load the 
   mouse driver at 9600 baud (either at the command line with MOUSE 9600 or 
   by loading CLICK after MOUSE in the AUTOEXEC.BAT file).

The proper scaling factors for both selections are as follows:

	Fast Motion Factor:  10
	Fast Motion Threshold:  1 or 2

NOTE: Earlier version of AutoCAD offered three button support for Series 9 
      and Series 7 mice. The selection was for LOGITECH LOGIMOUSE. When 
      using this selection, the command MOUSE 9600 must be used (as in 
      option 2 above).


For Logitech PS/2 mice (all models) use the following selection:

1]   Install ACAD with the IBM PS/2 mouse selection.



