=============================================================================
Installing the NEW Creative Labs CD-ROM Driver in OS/2 2.1
SBCD2.ADD Version 1.21
=============================================================================
You should replace any earlier version with this new driver.

INSTALLING SBCD2.ADD to an existing OS/2 system

1. Check that you have the following lines in your CONFIG.SYS.  If these 
	lines are missing, add them to your CONFIG.SYS and make sure that they 
	are located in your OS/2 directory.  If these files are not in your OS/2 
	directory then you must follow the Selective Install procedure detailed 
	in your OS/2 manual, you must check the CD-ROM Drive box and select OTHER 
	for the type of CD-ROM Drive attached to your system.

	BASEDEV=SBCD2.ADD /P:xxx (Where 'xxx' is the I/O Address of the SB card)
	IFS=C:\OS2\CDFS.IFS /Q
	BASEDEV=OS2CDROM.DMD
	DEVICE=C:\OS2\MDOS\VCDROM.SYS

*NOTE:   A. These lines should be kept together in the CONFIG.SYS and they 
				MUST be in the order shown above!

			B. Make sure that you do NOT have any duplicates of these lines in 
				your CONFIG.SYS or  you will get an error every time OS/2 starts.

2. Copy the SBCD2.ADD file to the C:\OS2 directory.  In some cases this file
	may need to be located in the root directory of the C: drive.  If you  have 
	SBCD2.ADD in the OS/2 directory and OS/2 still will not recognize your 
	CD-ROM Drive then copy the file to the root directory.  This should solve 
	the problem.

INSTALLING OS/2 2.1 (Final release) From CD-ROM using SBCD2.ADD

1. Make backup copies of the two disks that come with the OS/2 2.1 CD-ROM.  
	Store the original disks in a safe place in case they are needed in the future.

2. Copy the SBCD2.ADD file to the new disk labeled "Diskette 1".

3. Next, add the following line to the file CONFIG.SYS found on the new disk 
	labeled "Diskette 1".  This line should come right before the line 
	"IFS=C:\OS2\CDFS.IFS /Q".

	 BASEDEV=SBCD2.ADD /P:xxx  (Where 'xxx' is the I/O Address of the SB card)

4. Reboot the system with the new disk labeled "Installation Diskette" and 
	follow the installation process accordingly.

5. After the installation is completed and your system has rebooted, you must 
	copy the files CDFS.IFS and OS2CDROM.DMD from the OS/2 installation disk 
	labeled "Diskette 1" into the OS2 directory on your hard drive, then  add 
	the following two lines to your CONFIG.SYS file that is located on the C: 
	drive.  So that you will be able to access the CD-ROM drive after the 
	installation process has completed.

		IFS=C:\OS2\CDFS.IFS /Q
		BASEDEV=OS2CDROM.DMD

6. Remember to reboot the system.
